|
|
 |
 |
 |
|
|
BATTERY PASTING BELTS
Battery pasting belts are installed on the battery pasting
machines in the battery (accumulator) production. The
battery pasting belt is conveying the net, which is treated
with paste.
Our belts YRM 460 can be used for the car and truck
batteries (the production size is adjusted according to the
needs of the customer) . We are producing the battery
pasting belts in the nonwoven form, made truly endless
according to the dimensions required by customer.As the
belts are produced in the nonwoven form and that treated
against chemicals, that gives them an advantage towards the
woven belts.
The advantages of the Konus Konex YRM 460 battery pasting
belts are:
· Longer duration of the belt
· Equal surface on the top and bottom of the belt as each
belt is grinded to the measure
· Equal thickness
· Long lasting surface and form as the belt is treated
against chemicals
· No joint – all the surface of the belt is the same
· As the belt fabric is not on the surface it is protected
inside the belt giving it better physical characteristics.
Technical characteristics:
Type Weight in g/m2 Thickness
YRM 460 5300 9,5 mm
|
|
Type |
Weight in g/m2 |
Thickness |
| YRM
460 |
5300 |
9,5
mm |
|
It is
very important to respect the instructions for use to get
the maximum lifetime of the belt.
Instruction for use :
The correct length of the battery pasting belt is the inside
circumference. To determine it, run a tape measure around
the pulleys and add 1/4". The belt must fit tight without
stretching it too hard. We are able to furnish any length
needed.Belts can shrink when stored for long periods. Store
belts in a cool and dry place. See direction arrows on belt
and install accordingly.
OPERATING INSTRUCTIONS FOR THE CARE OF NEEDLED PASTING BELTS
:
1.Before installing a new belt, thoroughly clean all rolls
and surfaces on the machine that come in contact with the
belt to remove hardened paste built up, especially on the
drive roll and squeeze roll.
2.Install belt on machine manufactures instructions. These
instructions are very important.
3.After belt installation, tighten the take up roller just
enough to take up slack, if any. Do not stretch the belt.
Make the belt wet with water with temperature 50-60 degrees
Celsius (120-140 degrees Fahrenheit). Allow belt to run
20-30 minutes without paste but with constant supply of
water for the belt to be wet. After that tighten the belt
and start with pasting.
4.The end of the shift, remove all paste from the belt
surface and machine components with plenty of water. Be sure
to remove all paste built up. Under reduced pressure and
tension wash for about 5 minutes with plenty water in order
to flush as much paste out of the belt as possible. This
will prevent the belt from hardening and cracking later on.
Stop the machine. Relieve pressure on both squeeze roll and
take up roll. Move the belt splice to a flat position away
from any pullers or rollers and keep the belt saturated with
water until the next shift. Belt life is shortened when it
is allowed to dry out.
5.Belt must be always kept wet, also when machine is not
running.
|
 |
|
|
 |
| |
|
